|
Collins R-390A · SSB History
SSB and the Collins R-390A: From Military Converters to SDRsHow R-390A owners have copied SSB since the 1950s: the CV-591A and CV-157 converters, Lee’s product detector, the Lankford mod, the SB-390 and SDRs.
|
The Collins R-390A reached the military in the mid-1950s as a receiver for AM, CW and MCW. Within a few years single sideband had taken over much of military and amateur HF voice, and R-390A owners have been finding ways to copy it ever since. This is the story of those ways, from rack-mounted Navy converters to the software-defined radios that now sit beside many R-390As. For hands-on instructions, see the R-390A SSB how-to. For a side-by-side look at today’s options, see the SSB adapter comparison guide.
A Receiver Built Before SSB
Collins introduced the R-390 in 1950, and the R-390A followed in the mid-1950s. The r-390a.net FAQ lists its modes as AM, MCW and CW. Chuck Rippel summed it up on the R-390 mailing list in 1997: the R-390 family “were designed before the general acceptance of SSB.”
SSB arrived quickly. TIME reported in February 1959 that a 1956 Strategic Air Command test flight using Collins SSB equipment had convinced the Air Force. By 1959 almost every SAC aircraft carried SSB, and thousands of US amateurs had installed SSB sets since 1957.
The R-390A’s designers had left a door open: a separate 455 kHz IF output on the rear panel for an external demodulator. Captain Paul H. Lee later wrote that the receiver needed an outboard converter for satisfactory SSB reception, and that it had been designed to feed one.
The Military Answer: Outboard Converters (1950s–1960s)
The services didn’t modify their receivers. They added a converter that took the 455 kHz IF and did the sideband detection itself.
- Collins CV-157/URR. Accounts on the R-390 mailing list credit Collins with the original design and describe a 1950s unit of more than 40 tubes, built into a drawer, giving both upper and lower sidebands. Lee noted that receiving independent sideband needed either one CV-157 or two CV-591s.
- TMC CV-591/URR (Model MSR-1). The Technical Materiel Corporation of Mamaroneck, New York, built this much smaller converter. The Navy’s Bureau of Ships approved its manual in January 1958. It works with any receiver whose IF is centred on 455 kc, selecting either sideband by crystal or tuning with a VFO.
- TMC CV-591A/URR. Its 1968 Navy manual describes it as normally used with the R-390A/URR. It handles USB, LSB, AM, CW, MCW and frequency-shift signals. A 438 kHz or 472 kHz crystal, for LSB or USB, mixes the 455 kHz IF down to about 17 kHz, where a filter selects the sideband and a 17 kHz BFO restores the carrier. It is a 24 lb, 19-inch rack chassis, and Navy Radio’s photo archive shows the pair installed together aboard ship.
Similar adapters served civilian receivers with 455 kHz IFs, such as TMC’s GSB-1 from about 1957 and Hammarlund’s HC-10 SSB Receiving Converter, covered in QST in May 1957.
Do It Yourself: Captain Lee’s Product Detector (1963)
Converters were big and expensive, so owners began modifying the receiver itself. Captain Paul H. Lee, USN, W3JHR, wrote one of the best-known conversions. The r-390a.net compilation dates it June 1963, and Hollow State News #40 cites its publication in CQ in January 1968. Lee replaced the 6BA6 BFO tube (V505) with a 6BE6, whose oscillator section became the BFO while its injection grid took the IF signal, turning the stage into a product detector. He also added 1.0 µF to the FAST AGC position, which he found too fast for voice. He estimated under two hours of work and less than ten dollars in parts.
The Hollow State News Years (1983–2002)
Hollow State News, begun by Skip Arey in 1983 and published until 2002 (53 issues in all), became a meeting place for R-390A owners. Its best-known SSB contribution was the 2-diode AGC modification. It grew out of the Cornelius AGC mod in issues 1 and 10, which replaced a resistor with a diode. Dr. Dallas Lankford published his simpler two-diode version in issue 23 (Fall 1989), and issues 27 and 36 revisited it. Lankford first suggested the 1N270 diode and later the 1N4148 or 1N914, and by 2000 list members had confirmed the 1N4148 gave better AGC. Rather than adding a detector, the mod fixed the AGC so the receiver could run at full RF gain on SSB. It is cheap, reversible and still the most popular SSB improvement for the R-390A.
Lankford also reviewed SSB adapters in the newsletter, including one in issue #10. Issue #50 (Summer 2000) was Reid Wheeler’s last as editor. You can read the issues in this site’s Hollow State Newsletter archive, and more about Lankford in his Boatanchor Legends tribute.
The Mailing-List Era (1997–2000s)
The R-390 mailing list took the debate online. Its archives, gathered in r-390a.net’s SSB conversion compilation, show a burst of solid-state designs, all fed from the IF OUT jack:
- Vintage Radio Products PD-1: sold through Electric Radio for $129.95 in 2000, with an off/AM/LSB/USB switch, line-level audio, a plug-in power supply and a cable for the IF output.
- Ed WB2LHI’s detector: an MC1496 product detector fed from the IF output (1999).
- OH2BRY’s adapter: plugged into the IF output with no modifications, and about 70 people asked for the schematic (2000).
- Steve Johnston’s synchronous detector kit: built around the same IC as the Sony ICF-2010 (2000).
- Sherwood Engineering SE-3: Rob Sherwood’s (NC0B) outboard detector, already in its Mk III version by 1997. It locks to the carrier for synchronous AM on either sideband, and the Deluxe version adds a variable BFO for SSB and CW. A 2006 NASWA review priced it at $549. Chuck Rippel used an SE-3 III with his own R-390A.
Not everyone wanted any of it. Rippel told the list in 1997 that he didn’t modify the R-390A for SSB or recommend doing so, because it was built for AM and CW. In his experience converters like the CV-591 didn’t work all that well, and a receiver with sideband switch positions did no better than simply turning on the BFO.
Treetop Circuits and the SB-390 (2009–present)
The most successful modern adapter came from Bob Thomas, VE3TOU, whose Treetop Circuits ran from 2009 to 2022 and shipped more than 700 units across its models. The SB-390, introduced in 2013 and refined through five revisions, was built specifically for the R-390 and R-390A. It mounts on the receiver’s rear terminals, draws power from the receiver and leaves AM untouched, adding a product detector and a dual-time-constant AGC. When Bob closed Treetop, Perry Sandeen, KM6FQV, bought the business in late 2022. It passed to the author in 2026.
The SB-390 is no longer in production. Copies of its schematics and build notes have circulated in the community, but the designs have not been formally released into the public domain by the business’s current owner.
The SDR Era
Today the IF OUT jack often feeds a software-defined radio. Tapping the 455 kHz IF gives a panadapter view of the signals around the tuned frequency, and some owners take the signal before the IF filter for a display about 50 kc wide. Others leave the receiver untouched and share the antenna instead, as in this site’s Hermes Lite 2 companion panadapter guide. The SDR can demodulate SSB itself, which closes the circle: as with the CV-591A nearly seventy years ago, the sideband detection happens outside the receiver.
Timeline
| Year | Event |
|---|---|
| 1950 | Collins introduces the R-390 |
| Mid-1950s | R-390A production begins |
| 1956 | A Strategic Air Command test flight with Collins SSB equipment convinces the US Air Force |
| 1957 | Hammarlund HC-10 SSB converter covered in QST; TMC GSB-1 adaptor appears about this time |
| 1958 | Navy Bureau of Ships approves the manual for TMC’s CV-591/URR (MSR-1) |
| 1963 | Capt. Paul H. Lee’s R-390A product detector conversion (later published in CQ, January 1968) |
| 1968 | Navy manual for the CV-591A/URR, normally used with the R-390A |
| 1983–2002 | Hollow State News; the Cornelius AGC mod (issues 1 and 10) and Lankford’s 2-diode version (issue 23, 1989) |
| 1997–2000 | R-390 mailing list SSB debate; PD-1, WB2LHI and OH2BRY detectors |
| 2006 | NASWA reviews the Sherwood SE-3 |
| 2009 | Bob Thomas, VE3TOU, starts Treetop Circuits |
| 2013 | Treetop SB-390 introduced |
| 2022 | Treetop closes; Perry Sandeen, KM6FQV, buys the business |
| 2026 | Treetop passes to Mike Peace, VK6ADA |
Frequently Asked Questions
Can the Collins R-390A receive SSB?
The Collins R-390A was designed before SSB was generally accepted, and its listed modes are AM, MCW and CW, but its designers provided a separate 455 kHz IF output on the rear panel to feed an external demodulator. Owners have copied SSB through military converters such as the CV-591A, Captain Paul Lee’s 1963 product-detector conversion, the Lankford AGC modification, outboard adapters and, today, software-defined radios fed from the IF output.
What was the TMC CV-591A/URR SSB converter used with the R-390A?
The TMC CV-591A/URR is a Navy single-sideband converter normally used with the R-390A/URR, taking the receiver’s 455 kHz IF and performing the sideband detection itself. A 438 kHz or 472 kHz crystal mixes the IF down to about 17 kHz, where a filter selects LSB or USB and a 17 kHz BFO restores the carrier. It also handles AM, CW, MCW and frequency-shift signals, and is a 24 lb, 19-inch rack chassis described in a 1968 Navy manual.
What is the Lankford 2-diode AGC modification for the R-390A?
The Lankford 2-diode AGC modification is a simplified R-390A AGC change published by Dr Dallas Lankford in Hollow State News issue 23 (Fall 1989), developed from the earlier Cornelius AGC mod. Rather than adding a detector, it fixes the AGC so the receiver can run at full RF gain on SSB. Lankford first suggested 1N270 diodes and later the 1N4148 or 1N914, and the mod remains cheap, reversible and the most popular SSB improvement for the R-390A.
What is the Treetop Circuits SB-390 SSB adapter for the R-390A?
The SB-390 is an SSB adapter built specifically for the R-390 and R-390A by Bob Thomas, VE3TOU, of Treetop Circuits, introduced in 2013 and refined through five revisions. It mounts on the receiver’s rear terminals, draws power from the receiver and leaves AM untouched, adding a product detector and a dual-time-constant AGC. The SB-390 is no longer in production; Treetop Circuits passed to Perry Sandeen, KM6FQV, in late 2022 and to Mike Peace VK6ADA in 2026.
Sources & Further Reading
- SSB conversion compilation, 1963–2000 (r-390a.net), including Capt. Paul H. Lee’s 1963 article and R-390 mailing list posts
- R-390 series FAQ: overview (r-390a.net)
- Science: Power on the Side (TIME, 16 February 1959)
- Single Sideband Converter CV-591/URR, Model MSR-1: manual (1958)
- CV-591A/URR technical manual, NAVSHIPS 0967-051-2010 (1968)
- Navy Radio: receivers
- TMC CV-591A/URR and TMC GSB-1 (Radiomuseum)
- Hammarlund HC-10 (Radio Alpha collection)
- Hollow State News #40
- Sherwood SE-3 review (NASWA Journal, 2006)
- Perry Sandeen on buying Treetop Circuits (R-390 mailing list, 2023)
- Bob Thomas, VE3TOU, Perry Sandeen, KM6FQV, Dr. Dallas Lankford and Chuck Rippel: Boatanchor Legends tributes (VK6ADA)
- SSB on the Collins R-390A: BFO Technique and the Lankford 2-Diode AGC Mod (VK6ADA)
- R-390A Aftermarket SSB Adapters: A Comparison Guide (VK6ADA)
| Mike Peace VK6ADA / r-390a.net and foxtango.org Administrator |